Thingiverse
LIdl glider canopy latch
door MakerJDC
9
Downloads
13
Likes
0
Makes
Remixed to make it smaller enough to fit a Lidl foam glider (or any small rc plane).
Printed in PETG. Rod is a 1,5mm CF rod (this inserts into a CF tube glued inside the canopy). Spring from an old ballpen
Cut a small foam section in the top of the fuselage, at the back of the canopy, carve the foam until the latch fits and then cover the latch with the foam.
Printed in PETG. Rod is a 1,5mm CF rod (this inserts into a CF tube glued inside the canopy). Spring from an old ballpen
Cut a small foam section in the top of the fuselage, at the back of the canopy, carve the foam until the latch fits and then cover the latch with the foam.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!