Thingiverse
Lift & Pull Door Hardware
door jbrockman525
4
Downloads
2
Likes
0
Makes
A door panel mechanism I made for my Ender 3 enclosure. I had a thin panel of acrylic on hand, but needed something that would add some structure. I also wanted to make something a little more interesting than just hinges and a handle. This is made to install on a 3/4" wide surface. The panel lifts up and then pulls out to remove and then you push in and then down to secure.
The handles pictured are also my design and can be found here:
https://www.thingiverse.com/thing:5324885/files
The handles pictured are also my design and can be found here:
https://www.thingiverse.com/thing:5324885/files
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
