Thingiverse
Light and fan switch pull.
by u_c
0
Downloads
0
Likes
0
Makes
Pull for light, lamp or ceiling fan cords.
The hanging photo is printed with 100% infill and is solid. The photo on the table is 15% infill with the gyroid infill pattern. Both are printed with translucent PLA filament so that they have an interesting look.
Height : 50mm
Max width : ≈29.3mm
Min width : ≈25.8mm
Hole diameter : 3 - 4mm
The hanging photo is printed with 100% infill and is solid. The photo on the table is 15% infill with the gyroid infill pattern. Both are printed with translucent PLA filament so that they have an interesting look.
Height : 50mm
Max width : ≈29.3mm
Min width : ≈25.8mm
Hole diameter : 3 - 4mm
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
