Cults3D
€ Paid
Art
Zum Modell
Light box/Lamp Peugeot
0
Downloads
0
Likes
0
Makes
The file was carefully hand-drawn in CorelDRAW as a clean vector design, then converted into a 3D object in Fusion 360. This ensures clean straight lines, precise angles, and smooth curves.
The light box is fully ready for printing.
The box consists of two parts — a front and a back piece. The LED strip is attached to the back part, with a 3.5 mm opening for the cable. The back piece is glued to the front piece, leaving a 0.2 mm tolerance for easier assembly and featuring a 7 mm internal guiding edge.
C200 wood glue was used for assembling the parts. It dries in about 30 minutes, giving you enough time for careful and stress-free assembly.
The file is fully prepared for printing, and all necessary settings have already been completed.
The light box is fully ready for printing.
The box consists of two parts — a front and a back piece. The LED strip is attached to the back part, with a 3.5 mm opening for the cable. The back piece is glued to the front piece, leaving a 0.2 mm tolerance for easier assembly and featuring a 7 mm internal guiding edge.
C200 wood glue was used for assembling the parts. It dries in about 30 minutes, giving you enough time for careful and stress-free assembly.
The file is fully prepared for printing, and all necessary settings have already been completed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
