Thingiverse
Light dimmer switch fixer
por rakoivun
0
Descargas
1
Likes
0
Makes
My dimmer nobs have very flimsy plastic sticks which are squeezed around a plastic stick which controls lights.
Several times the thin sticks break (if you tilt the nob by using it a bit more forcefully).
The solution is to print small plastic circle with whole in it. Then glue this to back of the nob (after cleaning the nob).
The fancy 3 "legs" are so that the printed plastic will be centered correctly. This is important as if it is not centered the nob will wobble.
Used Fusion 360. PLA filament, 0.4 nozzle, 0.35 layer, Pricaslicer.
Several times the thin sticks break (if you tilt the nob by using it a bit more forcefully).
The solution is to print small plastic circle with whole in it. Then glue this to back of the nob (after cleaning the nob).
The fancy 3 "legs" are so that the printed plastic will be centered correctly. This is important as if it is not centered the nob will wobble.
Used Fusion 360. PLA filament, 0.4 nozzle, 0.35 layer, Pricaslicer.
rakoivun también publica en
48 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
