"Light It Up" Bookmark

I'm obsessed with the look of a catchy phrase or even a snarky saying showing not only where I left off in my book but also either what interrupted my reading (i.e. the kids started fighting) or my favorite book quote (i.e. you do not yield)! These bookmarks do just that! IMPORTANT: Due to the size and height of these bookmarks, they can be finnicky, so please follow my settings and work with a clean build plate. I have tested these again and again and finally found settings that work without warping or misaligning. I work on a P2S, and it's the only printer I am truly familiar with. However, if you run into any issues, please message me, and I will do my best to help you troubleshoot! As a general rule of thumb for this design, I HIGHLY recommend a LARGE brim (mine is an outer only at 15mm), a slightly higher heat setting on your plate (mine is 60 on the textured plate), and a lower cooling setting (mine is 80%). Without these, the design can warp at stress points. If you are interest