Thingiverse
Light Switch Cover
door lessonpix
181
Downloads
116
Likes
2
Makes
I needed a light switch cover to keep the outside motion-sensor triggered lights powered without rewiring. I also wanted to be able to leave one side open for when you really do want to adjust the switch.
I found this one on the site: http://www.thingiverse.com/thing:6688
I made it and it worked, but it's too thin on one side and I wanted to print it on glow-in-the-dark PLA so I could see switches when the lights were off & it didn't print well on PLA.
SO, I started from scratch and made my first Fusion 360 project. I've shared the STL and what I think are all of the Fusion files you'll need to recreate it. It turned out great - much more solid and it glows well.
For stability, I printed it with 100% infill, but it's probably not necessary.
Note: I printed this flat side down (not sure why the Thing Viewer rotated it)
I found this one on the site: http://www.thingiverse.com/thing:6688
I made it and it worked, but it's too thin on one side and I wanted to print it on glow-in-the-dark PLA so I could see switches when the lights were off & it didn't print well on PLA.
SO, I started from scratch and made my first Fusion 360 project. I've shared the STL and what I think are all of the Fusion files you'll need to recreate it. It turned out great - much more solid and it glows well.
For stability, I printed it with 100% infill, but it's probably not necessary.
Note: I printed this flat side down (not sure why the Thing Viewer rotated it)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
