Thingiverse
Light Switch Guard UK
von richsimpson
0
Downloads
3
Likes
0
Makes
I didn't find quite what I needed so created my own...
This is to cover a light switch or in my case a fused spur switch. Where the switch is still accessible, but to avoid the switch being operated unintentionally.
Low profile compared to others I have seen and tried but similar logic.
The screw hole is countersunk, 4mm profile with a larger 8mm profile for the protecting cap.
I printed face up and with support under the switch guard to get the nicest finish on the exposed surfaces.
This is to cover a light switch or in my case a fused spur switch. Where the switch is still accessible, but to avoid the switch being operated unintentionally.
Low profile compared to others I have seen and tried but similar logic.
The screw hole is countersunk, 4mm profile with a larger 8mm profile for the protecting cap.
I printed face up and with support under the switch guard to get the nicest finish on the exposed surfaces.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!