Light up Skull Pendant

Check out this Skull pendant. Welcome to my Light up skull pendant- snappy title eh! This model has light up eyes using only 2x 5mm LED’s and 1 cr2032 battery. Be careful with higher shrinkage filament as this might make the led and battery fit tricky. No soldering is required you simply install the LED’s, then bend the legs to fit either side of the battery. This model is predominantly a pendant but can be used anywhere Note the print time is not as quick as it could be but I have used variable layer heights to give a good looking print. I don’t recommend going to a uniform layer height is this will give you a very poor surface. see instructions attached :) Check out my other halloween modelsBoost Mespread a little spooky love with a boost