Lightbox - dragon

Dragon LightboxA square lightbox with a dragon front. The front is held in by a little shelf and should stay put without glue so you could print multiple fronts (see my other models) and swap them as you like! Designed to take a 1m LED strip (has about 5cm left over if you use it as shown). I got mine on eBay and the picture shows the thing I searched for to get multi-function, multi-colour with a remote. I recommend you change the print order so the first layer prints white first. Lightboxes are notorious for little flecks of black in the white, so make sure the outside of your nozzle and your bed are super-clean before you start. If you have an A1 and some patience then sit by it with a long cotton-bud/similar and (carefully!) flick off any debris. There are two backbox versions, one with hanging holes and one without. There are 2 holes so you can stop it swinging under the weight of your USB cable which it would on one nail, and a template to hold on the wall to show where to bang t