Slicer Discord
Lighthouse and Benchy – 3D printable model from MakerOnline MakerOnline
Lighthouse and Benchy – Bild 1 Lighthouse and Benchy – Bild 2 Lighthouse and Benchy – Bild 3 Lighthouse and Benchy – Bild 4 Lighthouse and Benchy – Bild 5 Lighthouse and Benchy – Bild 6
Toys&Games

Lighthouse and Benchy

421 Downloads
209 Likes
0 Makes
Go to Model
benchy小船在随着波浪上下浮动,前面是金色的小鱼群在不断跃出水面,远处是灯塔的金黄色的探照灯在不断旋转。 Benchy's small boat was floating up and down with the waves, with a group of golden fish leaping out of the water in front, and the golden searchlight of the lighthouse spinning in the distance. 以下是安装图示: The following is the installation diagram: 为了稳定你的benchy,可以把它粘在中间高起的那片浪花上。 o stabilize your bend, you can stick it to the rising waves in the middle. 安装完成的整体尺寸大约长160mm,宽100mm,高150mm。 The overall dimensions after installation are approximately 160mm in length, 100mm in width, and 150mm in height.
Category
Toys&Games
Source
MakerOnline
Published
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

PandaN also publishes on

136 additional models across 2 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection