Thingiverse
Lights for Creality 3D Printer Enclosure
door matthijsbos
6
Downloads
4
Likes
0
Makes
Body printed in vase mode, solid base pops out very easy.
Body sections glued together with couplers.
Tapered End caps press fit into body.
Assembly:
- Glue lengths of body and couplers
- Route led strips through slots (wires pre-soldered)
- Install sockets into endcaps, pre-soldered wires (1 long that runs through the groove in the back, one short)
- Press fit end cap with long wire into one end of the body, run cable through groove. Hold in place with some hotglue
- Solder/crimp all wires together (4 pairs, 2 led strips and 2 endcaps)
- Test led strips
- Press Fit final end cap in place
https://www.creality3dofficial.com/products/3d-printer-enclosure-safe-quick-and-easy-installation
Holds two parallel lengths of LED strip: https://nl.aliexpress.com/item/1005002230353875.html
Total power consumption for 5 sections in photo ~0.6A@12V. 1A power supply is sufficient: https://nl.aliexpress.com/item/33042352760.html
Daisy chained using 5.5x2.1 jacks: https://w
Body sections glued together with couplers.
Tapered End caps press fit into body.
Assembly:
- Glue lengths of body and couplers
- Route led strips through slots (wires pre-soldered)
- Install sockets into endcaps, pre-soldered wires (1 long that runs through the groove in the back, one short)
- Press fit end cap with long wire into one end of the body, run cable through groove. Hold in place with some hotglue
- Solder/crimp all wires together (4 pairs, 2 led strips and 2 endcaps)
- Test led strips
- Press Fit final end cap in place
https://www.creality3dofficial.com/products/3d-printer-enclosure-safe-quick-and-easy-installation
Holds two parallel lengths of LED strip: https://nl.aliexpress.com/item/1005002230353875.html
Total power consumption for 5 sections in photo ~0.6A@12V. 1A power supply is sufficient: https://nl.aliexpress.com/item/33042352760.html
Daisy chained using 5.5x2.1 jacks: https://w
matthijsbos publiceert ook op
69 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
