Lightsaber MK III

The MK III aka the Serin Fel v3, my third Blender lightsaber, modeled after my personal lightsaber that I machined from aluminum once upon a time. I wasn't able to do the lateral cuts in the Grenade section when I machined the original parts (don't have a mill), whereas this is closer to my original sketch. Someone offered to buy my prototype years ago, and I haven't had a version of this hilt since. Now I can 3D print the parts whenever I choose, and so can you.


The parts on this guy are all manifold and ready for printing. The coupling surfaces are the same as the MK II making it so the parts could be swapped between the two, and a 1.25" OD aluminum core tube can also be used. The tolerances are pretty tight (or were on the MK II) for a slip/snap fit, so I have not included holes for set screws. I also plan on gluing some sections since I don't want to use set screws or retention pins. If I rig this for electronics and a 1" OD blade, I'll end up just drilling and tapping a hol