Thingiverse
Lightsaber Stand
by AndyCa
45
Downloads
65
Likes
0
Makes
A quick display base for Lightsabers. Its nothing fancy, basic and doesn't detract from the saber, but paints up well enough.
The base is split into two halves, and likewise the support brackets, so you'll need to print two of these and glue them together( its too big to print in one go on my printer) . The support brackets get glued on top of the whole thing and to the round section of the base ( look at the image for glueup guide )
Again, nothing fancy, it just works..
The base is split into two halves, and likewise the support brackets, so you'll need to print two of these and glue them together( its too big to print in one go on my printer) . The support brackets get glued on top of the whole thing and to the round section of the base ( look at the image for glueup guide )
Again, nothing fancy, it just works..
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
