Thingiverse
Lightweight Corner Clamp
por Naughtyhorse
102
Descargas
75
Likes
0
Makes
I needed a corner clamp to hold some parts in place while I glued them. I didn't have one, so I made this thing!
it's good for holding components up to about 4mm thick, it's a little bit fiddly, but I am reasonably happy with it.
it's good for holding components up to about 4mm thick, it's a little bit fiddly, but I am reasonably happy with it.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
