Lightweight silicate container with threaded cap

by janpuddi · 3D Printer Accessories

220 Downloads

30 Likes

146 Makes

This small silicate container was designed to fit inside the hole of a filament roll.The slots are 1mm wide, allowing the silicate to breathe but not fall out of the container.The print uses approximately 9 grams and is ready in under an hour.The diameter of the container is 36mm, the height is 51mm Not suiteable for scaling! For larger, more stable silicate containers, you are welcome to have a look at my profile! :) Boost MeLiked it? A boost means a lot – thank you!