Lillabo compatible crane with hook

It's a crane that goes on the back of the Lillabo cars by Ikea. This model has been in the works for a long time, but I think I've finally gotten it refined enough to release. There is a bit of assembly required, A piece of filament and a lighter will hold the hook to the boom. A drop of superglue on the filament might work too, but heating the ends of the filament, and squishing them together works quickly, easily and mess free. The long pivot pin should slide in the hole in the body, holding the boom in place. It might be a tight fit, and you may need to size it to fit with some sand paper or a scalpel. The pivot pin for the base may need a drop of superglue to hold it in. If you use glue, us a very minimal amount, you dont want it to run everywhere, and accidently glue everything together! <img src="https://makerworld.bblmw.com/makerworld/model/DSM00000001879320/design/2025-10-12_6209743790c0