Thingiverse
LimeSDRmini Case
von Hagster
16
Downloads
11
Likes
2
Makes
A 3D printed case for my LimeSDRmini. Provides protection for your delicate radio.
The Lime slides neatly into the main case and the end cap clips securely around the SMA connectors.
10/3/2018 - V2+V3 version tested with LimeSDRmini.
14/4/2018 - V4 replaces previous versions. This version is 1mm longer to allow the LimeSDR to fit better. DesignSpark Mechanical Source files added. STEP files added
Print vertically. No need for support.
If you need an SDR antenna then please consider my UWB Vivaldi Antenna
Specs : - https://hexandflex.com/2018/02/28/ultra-wideband-antenna-lab-measurements/
Tindie Store :- https://www.tindie.com/products/11151/
The Lime slides neatly into the main case and the end cap clips securely around the SMA connectors.
10/3/2018 - V2+V3 version tested with LimeSDRmini.
14/4/2018 - V4 replaces previous versions. This version is 1mm longer to allow the LimeSDR to fit better. DesignSpark Mechanical Source files added. STEP files added
Print vertically. No need for support.
If you need an SDR antenna then please consider my UWB Vivaldi Antenna
Specs : - https://hexandflex.com/2018/02/28/ultra-wideband-antenna-lab-measurements/
Tindie Store :- https://www.tindie.com/products/11151/
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
