Thingiverse
Limit Switch Mounting Case Snap Fit
di Cogvet
4
Download
8
Likes
0
Makes
Snap fit for a generic (red) limit switch that comes bundled with the cnc uno shield version 3.
No screws needed but is difficult to remove one it is snapped into place.
Print support is needed for the two 2.8 mm horizontal posts. The funny left ledge is a necessary artifact that will be corrected to a retaining ledge when sliced. The top groove is in a good position for securing with a zip-tie as in my case.
The base dimensions came from Costmo's Limit Switch Bracket which is a good choice for securing with screws. I didn't have any screws so I screwed with that design instead.
Customize to your particular set up here: https://www.tinkercad.com/things/lKeDmawOSl5
This thing was made with Tinkercad.
No screws needed but is difficult to remove one it is snapped into place.
Print support is needed for the two 2.8 mm horizontal posts. The funny left ledge is a necessary artifact that will be corrected to a retaining ledge when sliced. The top groove is in a good position for securing with a zip-tie as in my case.
The base dimensions came from Costmo's Limit Switch Bracket which is a good choice for securing with screws. I didn't have any screws so I screwed with that design instead.
Customize to your particular set up here: https://www.tinkercad.com/things/lKeDmawOSl5
This thing was made with Tinkercad.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
