Line6 Pod Feet

This is a replacement for the rubber feet that attach a Line6 Pod (guitar effects processor) to an amp handle loop via the metal flange stand. I've been looking for these for years and still can't believe I never found them, since I feel like this is the sort of thing 3D printing is perfect for.

The originals were always pretty loose-fitting, and they got lost one by one over months of gigging. These actually stay firmly in the mounting holes in the flange/stand, so are a bit of an improvement. I printed using Ninjaflex at 100% on a Printrbot Simple. The front mounting holes are a little bigger than the back ones, so if doing it again I might try printing two at 103% and two at 100%.

I imagine these would work the same on the Bass Pod models. Let me know if these come in handy!