Thingiverse
Linear bushing anet a8
von Mads220
8
Downloads
11
Likes
0
Makes
These are Linear bushings for Anet a8
READ THIS TIPS: you should make 7 of these right away so when your stock ones finally give out you already have the spare! I had to buy 2 stock ones just to make these and it was very annoying!
They also should probably be dragged a bit like i do in the video! Only for a minutte or so to make the fit just right :)
They are MUCH more silent than the stock ones and very easy to print! Watch the video and you will understand :)
Good Luck everyone!
https://www.youtube.com/watch?v=20GVfLLLN9o
READ THIS TIPS: you should make 7 of these right away so when your stock ones finally give out you already have the spare! I had to buy 2 stock ones just to make these and it was very annoying!
They also should probably be dragged a bit like i do in the video! Only for a minutte or so to make the fit just right :)
They are MUCH more silent than the stock ones and very easy to print! Watch the video and you will understand :)
Good Luck everyone!
https://www.youtube.com/watch?v=20GVfLLLN9o
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
