Linear guide Y for Chiron

English:

I have modified the Y axis of the chiron with two linear guide.
You can print on the Y axis up to 100mm/s with acceleration 3000 without problems.
By removing a lot of weight the quality of printing on this axis can be increased considerably.

Files to print:
1 x Guide_eje_linear_china_40-20.STL
2 x MGN12H_V2.STL
2 x MGN12H_V2_mirror.STL
2 x LiftCorreaCama.STL
1 x Chiron-Z-endstop(reflejada).stl (optional)

Instructions:
Remove the bed by removing the wheels and store them.
Disassemble the belt and store the screws.
Mount the guides on the top and inside of the profiles.
Use the clamp to center the linear guide.
Once the guide is centered. Use a cutter to remove the decorative plastic. Remove the excess part of the plastic.
Center the guides well with the clamp and tighten well using the tnuts and M3 screws.
Assemble the 4 pieces MGN12H_V2.STL on the blocks MGN12H.
Mount 2 LiftCorreaCama.STL to lower the belts and screw it.
In case you need it, print Chiron-Z-endstopreflejad