Linear Rail Snapmaker 2.0 A350

Linear Rail holder for Snapmaker 2.0 A350.
Suitable for the following linear guides SBR16 750mm - 800mm

https://de.aliexpress.com/item/1005001468106943.html?spm=a2g0o.productlist.0.0.5b8f404cZnIwAE&algo_pvid=34808798-e00a-45da-9fa1-ac3e6492ac46&algo_exp_id=34808798-e00a-45da-9fa1-ac3e6492ac46-10&pdp_ext_f=%7B%22sku_id%22%3A%2212000016238249293%22%7D&pdp_pi=-1%3B66.28%3B-1%3B5.0%40salePrice%3BCHF%3Bsearch-mainSearch

The following screws are also needed:

Flat head M5x20

PLASTIC SCREWS EJOT PT® WN 1452 2.5 x 6mm

The 4 adapter plates are mounted on the 4 slides. When doing so, the holes of the slides and the alignment of the bed based on the linear guide must be observed. The distances between the holes are 30 x 32 mm each.

Then the holders are clipped in at the front and rear. The linear guides are now pushed through and then the front carriage and then the rear carriage are inserted before it then goes through the 2nd holder. Align the two linear guides and then use a