Thingiverse
Linear Slide for 8020
von mgx
86
Downloads
62
Likes
0
Makes
A captive linear slide carriage for 8020 aluminum extrusion size 1010 (1"). It uses 3 out of 4 sides, leaving one T-slot free to attach to something else.
The carriage slides very easily with a balanced load, especially if oiled a little bit, but it will bind with small side loads. It is not meant as a part for 3D printers / CNCs, it will probably not take extended use really well.
It has two 1/4" screw holes to attach to a perpendicular extrusion or directly to a camera tripod mount.
The carriage slides very easily with a balanced load, especially if oiled a little bit, but it will bind with small side loads. It is not meant as a part for 3D printers / CNCs, it will probably not take extended use really well.
It has two 1/4" screw holes to attach to a perpendicular extrusion or directly to a camera tripod mount.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
