Thingiverse
Linksys Velop AC Outlet Mount
von Rr9
6
Downloads
5
Likes
0
Makes
1. Slide the barrel jack through the hole in the bottom of the BASE
2. Stuff the chord in the BASE and slide the top piece on
3. There is a little cutout at the back of the TOP piece to put the barrel jack side of the power chord though
4. Place the router on top so the extrusions go through the holes at the bottom of the router
5. Use double-sided tape to stick the print to the top of the wall outlet
6. Glue the SUPPORT piece on the bottom of the BASE so the other side touches the white part of the socket.
2. Stuff the chord in the BASE and slide the top piece on
3. There is a little cutout at the back of the TOP piece to put the barrel jack side of the power chord though
4. Place the router on top so the extrusions go through the holes at the bottom of the router
5. Use double-sided tape to stick the print to the top of the wall outlet
6. Glue the SUPPORT piece on the bottom of the BASE so the other side touches the white part of the socket.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
