Thingiverse
LinkTap Gateway Wall Mounting Bracket
von eddytheflow
4
Downloads
2
Likes
0
Makes
Liked this mounting design so remixed it again for my LinkTap Gateway.
Again, reinforced the side braces as they were too flimsy when I printed them before.
If I were to make again, I would add maybe 1-2mm of play around the base. It fits snugly, quite tight, maybe too tight. At least it's secure!
Again, reinforced the side braces as they were too flimsy when I printed them before.
If I were to make again, I would add maybe 1-2mm of play around the base. It fits snugly, quite tight, maybe too tight. At least it's secure!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!