Lion BJD

This is a Lion Ball Jointed Doll based on the wonderful Cheetah model by dmstlrc(see remix links below) and the Lion Statue remix by cipis. The proportions for this model were changed from the cheetah to more resemble a lion as well as make it easier to print in resin and to assemble. This model is much larger than the cheetah overall, see pictures for scale. Due to this the joints are not as snap-in tight as the original and may need a thin layer of hot glue in the joints before assembly if printing with PLA(wait for the hot glue to set before assembling).

To assemble this you will need the following:

1. 8mm magnets for the head/face join. These can be glued in place by something like tacky glue. Just don't soak it in water after afterwards. You can probably use a smaller magnet if printing with PLA since it is not as heavy, but I always tend to use the biggest magnet that fits.
2. 2mm elastic cord to join all the pieces. See the diagram in the photos on how the doll is meant t