Lithophane box

For this box you will need 4 lithophane images. Dimensions width 90mm and height 138mm
Be sure that frame of the lithophane image must be 2mm depth and 2mm width in order to easily slide them into the frame.
I printed this lithophane with 0.12 layer height..but 0.16 works as well.
Everything else was printed with 0.2 layer height

I used 12V LED strip that i just wrapped around the central pillar.
I used just a regular on/off switch
12V power supply that has 2.1x5.5mm DC connector.

Assembly is quite easy.

No glue is needed.
You can easily swap the lithophanes, just unscrew the top lid and replace them, screw the lid back and that is about it.

Here is the link to my dropbox account where you can find Cura profile for Lithophanes (it is for Ender 3V2...but i think it should work just fine with Ender 3 pro)

https://www.dropbox.com/sh/qxfsctv3qv9ir43/AABhZ7iPWNVru63ebg7xuk9ya?dl=0


If you like my design consider supporting me: paypal.me/georgius225

For ad