Thingiverse
Lithophane Holder
door JoshRawdon
56
Downloads
47
Likes
0
Makes
Lithophane print holder. The base can accommodate a lithophane that's 3 mm thick by up to 222 mm wide. All parts dovetail together, so they can be printed separately and assembled/disassembled.
Depending on your printer's accuracy, the dovetails may be a little tight and need some sanding, as they were designed with no tolerance or slop.
Print with all of the dovetail profiles facing up, so that the layer lines aren't located at the corners of any of the dovetail joints, to increase strength. Will need a small amount of support for the bulb base holder dovetail, if you print it vertically.
May need to turn the long parts diagonally, since they are more than 220 mm long.
Designed to fit these light bulb bases: https://www.amazon.com/gp/product/B083587T29/ref=ppx_yo_dt_b_asin_title_o03_s00?ie=UTF8&psc=1
Depending on your printer's accuracy, the dovetails may be a little tight and need some sanding, as they were designed with no tolerance or slop.
Print with all of the dovetail profiles facing up, so that the layer lines aren't located at the corners of any of the dovetail joints, to increase strength. Will need a small amount of support for the bulb base holder dovetail, if you print it vertically.
May need to turn the long parts diagonally, since they are more than 220 mm long.
Designed to fit these light bulb bases: https://www.amazon.com/gp/product/B083587T29/ref=ppx_yo_dt_b_asin_title_o03_s00?ie=UTF8&psc=1
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!