Thingiverse
Lithophane Poker Chip
von gbertram
9
Downloads
6
Likes
0
Makes
This is a simple poker chip with a lithophane center. The files are the outer ring of the chip. I've included rings with the word "King", "Queen", "Ace" and "Joker". I've also included a blank ring in the event you would like to add your own text.
Printing
The Chip can be printed horizontally (flat) or vertically. I used a raft and supports for vertical prints. Either way will work, but the lithophane is cleaner and the chip surface is smoother if printed vertically. (For comparison, the chip of the man was printed horizontally and the bird vertically. You can also see the difference in the side-by-side) The center of the chip is a fairly small area, so it is best to use a close up of your subject.
Horizontal Printing Preparation
This is the simpler way to print the chip. (I use Cura, so the process may differ for other slicers) Open the photo or graphic in Cura. Resize the image to a 28mm x 28mm square. Open the ring, lay it flat and carefully orient over the i
Printing
The Chip can be printed horizontally (flat) or vertically. I used a raft and supports for vertical prints. Either way will work, but the lithophane is cleaner and the chip surface is smoother if printed vertically. (For comparison, the chip of the man was printed horizontally and the bird vertically. You can also see the difference in the side-by-side) The center of the chip is a fairly small area, so it is best to use a close up of your subject.
Horizontal Printing Preparation
This is the simpler way to print the chip. (I use Cura, so the process may differ for other slicers) Open the photo or graphic in Cura. Resize the image to a 28mm x 28mm square. Open the ring, lay it flat and carefully orient over the i
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
