Litter Robot Open Air Internal Shield Plug

This plug is used on a Litter Robot to allow removal of the internal shield on older models. This plug matches the plug design used on the newer models.

Printing:
I printed using PETG at 0.2 layer height with three perimeters on a Prusa I3.

To install:
(1) Remove the screw holding the key and shield in place.
(2) Remove the shield inside the litter robot
(3) Install plug and screw together again(with the plug in place of where the shield used to be).
The plug only fits in place in the correct orientation so rotate it if need be to install and fit into the mating part.