Little Elephant

Little Elephant:

I made this model to be the basis for a novelty Kossel J6 mount. I think it came out rather nicely so I thought I'd post the model as it's own thing.

Little_Elephant.123dx / .stl - the primary model
Hollow.stl - a hollow version
E_Box_Top.stl
E_Box_Base.stl - to make a little box
Wood_E_Box_Top.gcode
Wood_E_Box_Base.gcode - My setup to print a "wood-filament" version

...a little tip:
I find "wood-filament" even more ot a SOB to print than ABS. Not so much warpage but non-stickage.
I find the best solution for me is to ignore the bed temp advice and crank the temp up to about 70c, at least initially. Equally I start the print at the upper end of the filament's recommended temp and reduce to the middle of the range after two or three layers.