Thingiverse
Little Monster Direct Mount
von Sienna
16
Downloads
6
Likes
0
Makes
This mount allows a direct mount of the Titan Extruder to the Little Monster carriage.
Offsets the motor to be roughly center of the nozzle.
Bowden tube is ~98mm. Start there and start trimming to taste.
The overhangs are visually ugly, but it seems to print fine without supports.
The current posted item seems to have a good feed angle, but keep in mind I am still assembling my LM so I haven't printed with the setup yet.
Offsets the motor to be roughly center of the nozzle.
Bowden tube is ~98mm. Start there and start trimming to taste.
The overhangs are visually ugly, but it seems to print fine without supports.
The current posted item seems to have a good feed angle, but keep in mind I am still assembling my LM so I haven't printed with the setup yet.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
