Thingiverse
Little round box
door mazcunan
3
Downloads
2
Likes
0
Makes
Just a try on how to get a little box in three parts, one center thread and two caps.
It's about 3cm of internal diameter and 1cm o internal height.
Prints in an hour with no supports in a Zortrax M200 with 0.140mm layers and fits perfectly as seen on the photos.
The use of two caps in the design allows it to be used with bigger height inside.
It's about 3cm of internal diameter and 1cm o internal height.
Prints in an hour with no supports in a Zortrax M200 with 0.140mm layers and fits perfectly as seen on the photos.
The use of two caps in the design allows it to be used with bigger height inside.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!