Littlebug 125mm Quadcopter

This is a 125mm frame quadcopter frame I designed. It's best printed in Carbon Fiber, PETG, or ABS (in that order) as PLA is brittle and even a small crash will break an arm off.

I will rework the camera mount at some point as this was just a quick test and I got so into flying it I didn't go back.

Current setup weighs 134.8 grams (100% fill ABS) before you add a battery.
PIKO BLX flight controller
PIKO BLX OSD/VTX
FrSky XSR receiver
Littlebee 20a ESCs
RCX H1407 3200KV motors
Furios FPV antenna
600 TVL camera