MakerWorld
Hueforge & Lithophane
Go to Model
Lizard Dango - Bookmark
8
Downloads
11
Likes
4
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 55x163.62mm in sizeYou may print at higher layer heights below the Min Depth of 0.8mmThe Max Depth is 1.9mm and the Actual Depth is 2mm Filaments Used: PLA Aurapol Black Transmission Distance: 0.4 PLA Aurapol Grandma Gray Transmission Distance: 3.7 PLA Aurapol White Transmission Distance: 2.7This print uses 3 unique filaments (You can also use similar colors from other manufacturers) Swap Instructions: Start with Black At layer #12 (1.04mm) swap to Grandma Gray At layer #19 (1.6mm) swap to White for the rest.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
