LJ12A3 mount for Workbee

Her is some brakket for the workbee, i did not like the "end stop" micro switch, so i changes it to a Proximity Sensor LJ12A3.
I use M5 Low Profile Screws and Tee nuts.
Depending on which controller you use, you may need to connect a relay between the sensor and the controller.


NOTE:
"I was asked by Perseveranze to post some pictures of my build.
later I will make a separate build for my controller including the wiring and use of hardware"
And some picture of the things I milled out to my self.