LK4 PRO Direct Drive Mount

I've printed two direct drive mounts for my LK4Pro. And even though they have been described as dedicated to LK4 PRO, both of them were not aligned properly.

In my case they are about 1 mm too much to front and about 2 mm too much to the right.
That is why I decided to remix it, to fit my printer properly.

All of my printer parts (stepper motor, extruder, hotend, x axis carriage) are completely stock. So if you have the same problem with misaligned extruder/hotend as me, then try this mount.

I've recreated remixed parts and shifted the mount 1mm to the back and 2 mm to the left. I've changed a bit geometry of the stepper motor plate to fit the stock drive perfectly without any margins.

Layer: 0,15
Fill: 30%
Material: PLA
Support: YES

It may be needed to file a little a holes for the metal insert of the rolls. They should fit tight, so i decided to not oversize them in a project.

#DO NOT FORGET TO ATTACH BUMPER OR THE STEPPER MOTOR WILL HIT THE FRAME#
For example