Thingiverse
LM2596 Enclosure
von Klave
24
Downloads
21
Likes
0
Makes
Thing 1625233 doesn't work for my boards, the holes in the board are wrong and the trimpot is off to the side. The pins that go through the board are too thick and I had to cut them off.
This is a version that fits my boards, I've included a picture for you to compare. My board probably has one of those fake LM2596 IC's that operates at a low frequency.
I added some vents to release internal heat and also included a version that has the connection leads off to the side so that the capacitor isn't in the way.
The boards are slightly asymmetrical so I marked the IN and OUT ends so you can align the board. The lid will fit both ways so make sure you check the pot is visible.
For the side entry the lid will only fit one way
This is a version that fits my boards, I've included a picture for you to compare. My board probably has one of those fake LM2596 IC's that operates at a low frequency.
I added some vents to release internal heat and also included a version that has the connection leads off to the side so that the capacitor isn't in the way.
The boards are slightly asymmetrical so I marked the IN and OUT ends so you can align the board. The lid will fit both ways so make sure you check the pot is visible.
For the side entry the lid will only fit one way
Klave veröffentlicht auch auf
84 zusätzliche Modelle auf 3 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
