Thingiverse
LM8UU housing
door aeropic
1.9k
Downloads
1.1k
Likes
31
Makes
In the objective to shave some mass on the ANET's Y and X carriages, here is a standard sized LM8UU holder or housing.
It is designed to exactly fit the LM8UU linear bearing or any plastic one.
As it is parametric, you can customize it (open in customizer button at the bottom right of the image) in order to adapt it to your bearing and to the quality of your printer ;-)
Everything included, more than 20 grams per housing are won. Which means 84 grams recovered only for the housings of the Y carriage. If you change the LM8UU by those printed ones (highly advised ! see here: https://www.thingiverse.com/thing:2537701) 50 other grams are shaved ...
==> total gain of 134 grams... not too bad !
You will need small pins in order to lock the bearing in their housing (small holes are printed to insert the pin right in place, see the blue arrows in the picture of the X carriage).
My goal was to make those housing so that in case of wearing of the bushings they could be changed, o
It is designed to exactly fit the LM8UU linear bearing or any plastic one.
As it is parametric, you can customize it (open in customizer button at the bottom right of the image) in order to adapt it to your bearing and to the quality of your printer ;-)
Everything included, more than 20 grams per housing are won. Which means 84 grams recovered only for the housings of the Y carriage. If you change the LM8UU by those printed ones (highly advised ! see here: https://www.thingiverse.com/thing:2537701) 50 other grams are shaved ...
==> total gain of 134 grams... not too bad !
You will need small pins in order to lock the bearing in their housing (small holes are printed to insert the pin right in place, see the blue arrows in the picture of the X carriage).
My goal was to make those housing so that in case of wearing of the bushings they could be changed, o
aeropic publiceert ook op
5 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
