Locking Soap/Sponge Dish with Rack & Drip Tray

I was annoyed with the fact that my soap/sponge dish at my kitchen sink was always moving off the edge of the sink (and draining water all over the counter top). This design locks on to the sink edge and doesn't move! It also has an integrated dishcloth holder to hang up your wet dishcloth after doing the dishes. The drain pan of the print has a slope so water will drain out of the pan into your sink. Printed in eSun PLA+ with no issues. Single color profile currently offered, feel free to print the rack and body in different colors! Please note the print orientation in the profile - it is essential due to the overhangs. I tried to minimize the support filament usage but unfortunately this is not really avoidable. NOTE: The rack will not fit in the hole until the part has fully cooled down! Please be patient and allow the part to cool to room temperature. Then it should be a secure fit. Currently fits only on 256x256x256 beds, if there is a demand I may make one for the A1 mini (ra