Lockpick gun

Lockpicking gun (design concept):

the design and build instructions are not complete!
things may change. feel free to submit your ideas and
improvements.

1. print all parts and smooth all inside parts!
3. buy a metal measuring tape or use an old one
(e.g. https://www.amazon.de/dp/B0078E23NI/ref=cm_sw_em_r_mt_dp_U_rAivDb692EG6Q)
4. cut a 5cm part from the measuring tape.(will act as a special spring ...)
5. use the 2 trigger parts and glue them together.
6. cut the measuring tape sides to fit between the trigger and the lever.
7. glue the mesuring tape on the lever and take a m3 screw to fix the lever.
(but keep it move smooth)
8. follow the picture to complete the whole snap gun:

9. the back side of the handle is adjustable if you use a m3 screw
with 2 bolts you can configure the spring pressure.

Log:
15.08.19: (Blender file only)
- Allow more spring pressure.
- Pressure stick spring cut and fix.
- snap part allowed movement wall.
- deeper trigger hole imp