Logitech G27 Tilt Wheel Mod

Logitech G27 Tilt Wheel Mod allows you to print a wedge with 2 angled holes which fits between the Desk and the wheel bottom. This is used when the desk is drilled and wheel is hard mounted using the tapped 6mm holes on the underside of the G27/25 wheels (May work for newer wheels but I have none to test with). 2 Discs and 2 wedges are included to compensate for the angle of the wedge. Simply un-bolt your G27 wheel. Place the wheel wedge between desk and wheel. Place washer, and printed disc over 6mmx60mm bolt and push up through desk and the wheel wedge and lightly thread into the G27 wheel base. Keep wide end of disc's toward the drivers seat. do same for right side. Now snug but don't over tighten the main bolts. Place the printed Front Wedges between the front screw-up hook on the Wheel and the desk with the wide end toward the drivers seat. Tighten front hooks. Go run some laps.
There are 4 sizes that lift the back of the wheel by 10, 15, 20 and 25mm's. I have only printed and t