Logitech G930 Headphone Stand

This was a necessity for my daughter, she wanted a stand where the cord storage of the Logitech G930 would fit in the base. It uses a lot of plastic and took over 22 hours to print. There is not much more to say about it.

While not technically a remix it is based on the [GhostlyVinyl Headset Stand](http://www.thingiverse.com/thing:569923).

**v2:** Notch for cable made larger to account for the cable leaving the Logitech base off center.
**v2.5:** Same stand but modeled as if it were going to be injection molded in Asia, hollowed out on the back side with 3 mm walls for strength. This version requires support material since there is 0% infill.