Logitech k800 keycap clip repair

Replacement clips for Logitech k800 keycaps
May be too fine for FDM- I tried printing thise with PLA but it broke due to layer adhesion.
Please comment if you get better results with any other materials.

Works great when printed with SLA.

Remove the remainings of the old clips, sand flat.
Attach the replacement clips to the scissor part, put a tiny bit of superglue on the flat surface of the clips, insert the scissor part into the keycap and apply a bit of force.

After superglue dried remove the scissor part, install it into the keyboard then reattach the key cap.

Keycap will be just a bit at an angle due to added 0.2mm thickness, that's normal.

Blueprint in the photos, please report if it fits any other keyboards.