Slicer Discord
Logitech Streamcam Ultimate Cover – Modelo 3D imprimible de MakerWorld MakerWorld
Electronics

Logitech Streamcam Ultimate Cover

38 Descargas
11 Likes
20 Makes
Ver Modelo
Hello there!Yet another Logitech Streamcam Cover you might say, but noI've stumbled across a lot of covers but none of them had all the things I was searching for, so I designed one myself, following all the functionalitiesFlare protection from above lightnings without compromising the maximum angulation of the cameraBounded camera cover, with a practical 3*2 magnet you can keep it over the camera or in front of it, without taking the piece awayA design that keeps the microphone usable, since it's not bad at all I use it when I'm in voice calls, with this design it can detect the voice well keeping the camera coveredThe assembly is simple, you just have to glue the two main pieces togheter and slide the camera cover into the guides after gluing two 3*2 magnets inside the corresponding holes, being careful with the orientation!That said you can slide the model onto the streamcam from the above and enjoy your all-around accessory
Categoría
Electronics
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Intermedio Baja confianza
¿Por qué?
postproceso considerable
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 2/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Polycarbonate
Postprocesado
Pegado, Tornillería
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección