Logitech Wingman Dust Gasket

I had a Logitech Wingman Force for ages.
Was a great joystick and used for such a long time, but the silicone dust & centering gasket finally disintegrated.

For those who may still use this controller, this part will give it a bit of new life.

Note:

Must print with flexible filament (TPU - 95A,80A,60A)
This dust cover might work for a Logitech Extreme 3D joystick.
I cannot advise if this part will fit on any other Logitech joystick, as I do not own/have others to compare or test.


Recommended model is "Short-15mm" if using firmer TPU 95A filament.
Printing the full size gasket with 95A will cause too much movement resistance.


DustCover_FlatTaper-Short-15mm - TPU ~95A will work fine
DustCover_FlatTaper - Only Print this one with really soft/flexible TPU (60A,70A, maybe 80A)
DustCover_Spacer_Ring-Tapered - Use this to close off the center-hole gap


General Disclaimer:
By making/using this part, you take full responsibility for the handling and application of