LOGITECH Z533 HOLDER

UPDATE 17 JENUARY 2021:
- Correct geometry of " incastro" (it was 90° turned in a incorrect way)
- the The word "logitech" was, incorrectly, on the opposite side.

This is a kit to hold the Logitech Z533 speaker system.
I designed it for myself, and than I decided to share it.
STEP file are attached, so If you want you can improve
the system and share it again.

Note: print n°2 of "Incastro": n°1 for "mensola destra" and n°1 for "mensola sinistra"

IMPORTANT: the hanging bracket is designed for an ikea table,
which is approximately 34 mm thick.