Thingiverse
Logix Autotrol Injector Key
von Asterion72
0
Downloads
1
Likes
0
Makes
This key has been made to avoid to use each time the allen key to clean the injector of the Logix Autotrol water softener.
Use one 6mm metal allen key the first time to unlock the cap for the first time, because if it's too tight it could be too hard for your PLA key, after unlocking use silicon grease and open/close it with my key by hand.
Use one 6mm metal allen key the first time to unlock the cap for the first time, because if it's too tight it could be too hard for your PLA key, after unlocking use silicon grease and open/close it with my key by hand.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
