London Bus

The model is based upon the popular Routemaster bus operated by London Transport from 1956 to 2005 and now viewed as a British cultural icon. A new, redesigned version of the Routemaster entered service in 2012.

YOU WILL NEED TO PRINT:
2 axles
4 wheels
2 front mudguards
2 rear mudguards
2 headlights
and one copy of all the other parts.
I used ‘True Red’, ‘True Black’, ‘Cool Grey’ and ‘Warm Grey’ filaments. (See estimated printing times below.)

On my Makerbot Replicator+ I printed several pieces at the same time, (see estimated printing times below.) at the default settings of 10% infill and a layer height of 0.2mm. using rafts but no supports. All parts should be printed in the orientation shown.
The assembled parts can be fixed permanently into position with a few drops of Super Glue.
Route signs and number plates are printed onto thin card stock, cut out and glued into position. The signs I used are attached below for you to print out.

ASSEMBLING THE MODEL
Trim off